ANNEX 6a - Conducting Fishing Vessel Offset Load Test
Updated 31 January 2024
漏 Crown copyright 2024
This publication is licensed under the terms of the Open Government Licence v3.0 except where otherwise stated. To view this licence, visit or write to the Information Policy Team, 皇冠体育app National Archives, Kew, London TW9 4DU, or email: [email protected].
Where we have identified any third party copyright information you will need to obtain permission from the copyright holders concerned.
This publication is available at /government/publications/the-code-of-practice-for-the-safety-of-small-fishing-vessels-of-less-than-15m-length-overall/annex-6a-conducting-fishing-vessel-offset-load-test
1.1 An offset load test should be conducted when the Vessel is loaded according to the operating conditions set out below in as specified in 1.4.1 below taken from the IMO Publication 鈥淪afety Recommendations for Decked Fishing Vessels of Less than 12m in Registered Length and Undecked Fishing Vessels鈥�.
1.2 皇冠体育app test should be conducted in three stages.
Stage 1
A weight equivalent to one third of 25 x LOA x B (kgs) should be distributed along one side of the vessel,
where:
LOA and B, in metres, Length overall and beam
Stage 2
A weight equivalent to two thirds of 25 x LOA x B (kgs) should be distributed along one side of the vessel,
Stage 3
A weight equivalent to 25 x LOA x B (kgs) should be distributed along one side of the vessel,
1.3 皇冠体育app stability is deemed satisfactory when the angle of heel does not exceed 15掳 and the freeboard to the deck is not less than 75 mm at any point.
1.4 皇冠体育app owner must agree with MCA to use the following Operating Condition
.1 departure for the fishing grounds with full fuel, stores, ice, fishing gear, etc and empty hold.;
1.5 皇冠体育app same Vessel condition should be repeated at each subsequent test. 鈥�